« previous next »
Pages: [1]   Go Down

Author Topic: TAF transformer wiring  (Read 264 times)

0 Members and 1 Guest are viewing this topic.

Offline faza

  • Trade Count: (0)
  • ******
  • Forum Posts:
    • Sydney
TAF transformer wiring
« on: October 02, 2010, 07:40:44 PM »
Anyone got the wiring diagram of a TAF transformer particularly want to know the 9 pin molex connector on the primary side of the transformer.
Mine has been hacked and would like to replace the connector back to original.
Thanks

Just found what i was looking for aint the internet fantastic.
« Last Edit: October 02, 2010, 08:11:37 PM by faza »
Logged

Offline MartyJ

  • Trade Count: (+4)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Melbourne
Re: TAF transformer wiring
« Reply #1 on: October 02, 2010, 08:35:01 PM »
Ahh - you beat me too it.

I was about to take a photo of my new Addams for you but not needed!
Logged

Offline faza

  • Trade Count: (0)
  • ******
  • Forum Posts:
    • Sydney
Re: TAF transformer wiring
« Reply #2 on: October 02, 2010, 11:32:35 PM »
Well it seems like whoever bypassed the 9 pin molex connector connected the neutral to terminal 4 instead of terminal 7 machine still worked ok without any problems anyone know what tapping that would make it ?
Logged

Offline faza

  • Trade Count: (0)
  • ******
  • Forum Posts:
    • Sydney
Re: TAF transformer wiring
« Reply #3 on: October 03, 2010, 11:27:27 PM »
Anyone know ?
Logged

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: TAF transformer wiring
« Reply #4 on: October 04, 2010, 10:21:05 AM »
I am assuming 200v or 210v
i have not checked this but i have read some where about having low input voltages and how to over come them.
hope this helps
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)

Offline faza

  • Trade Count: (0)
  • ******
  • Forum Posts:
    • Sydney
Re: TAF transformer wiring
« Reply #5 on: October 04, 2010, 10:44:26 AM »
Thanks Beaky have replaced the plug and wired it for 230 Volts
Logged

Offline FirePower

  • Trade Count: (0)
  • *****
  • Forum Posts:
    • Sydney
Re: TAF transformer wiring
« Reply #6 on: October 04, 2010, 11:15:34 AM »
You could work it out if you're desperately interested.  Disconnect the incoming plug and measure the resistance between pins 3 and pin 5, call this R1. Also measure resistance between pin 3 and pin 8, call this R2.

The low tap voltage will be 230 x R1/R2
Logged
Pages: [1]   Go Up
« previous next »