Author Topic: STTNG Gun Assembly Plastic Arm  (Read 167 times)

0 Members and 1 Guest are viewing this topic.

Offline Skyntara

  • Trade Count: (+1)
  • **
  • Forum Posts:
STTNG Gun Assembly Plastic Arm
« on: August 18, 2011, 10:18:27 PM »
Hi Guys,

My left gun stopped moving properly and I discovered that the white plastic arm has previously been broken around where it connects to the gearbox shaft. It had be repaired poorly with glue, wire and a cable tie.

Just wondering if I can get that White plastic arm bit or if I have to order a whole assembly.

Cheers

Clancy

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
  • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: STTNG Gun Assembly Plastic Arm
« Reply #1 on: August 18, 2011, 11:47:25 PM »

The short Crank Arm - http://www.marcospecialties.com/product.asp?ic=03-8619

This is the same as "The Addams Family". Greg at RTBB might have these in stock.

Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia

Offline Skyntara

  • Trade Count: (+1)
  • **
  • Forum Posts:
Re: STTNG Gun Assembly Plastic Arm
« Reply #2 on: August 19, 2011, 12:46:28 AM »
Sweet, thanks heaps.

Couldn't seem to find it separately.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
  • Melbourne, Vic
Re: STTNG Gun Assembly Plastic Arm
« Reply #3 on: August 19, 2011, 04:48:23 AM »
I bought one from RTBB a few months ago.
You will have to drill a small hole through it for the roll pin which holds it to the metal shaft on the motor.

This is not Greg's fault but a manufacturing fault. If you buy the one from marco specialities you will have the same problem.

I am not knocking RTBB or Marco's, I am only letting you know so you don't need to make enquires about the missing hole

Greg when through every one he had in stock and they were all the same.

when I contacted marco's the said the same thing

save your self the postage and buy it from Greg
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)

Offline Skyntara

  • Trade Count: (+1)
  • **
  • Forum Posts:
Re: STTNG Gun Assembly Plastic Arm
« Reply #4 on: August 19, 2011, 10:18:03 PM »
So I drive the pin out of the gearbox shaft then drive it back in through my freshly drilled hole?

Offline rads

  • Trade Count: (+1)
  • *****
  • Forum Posts:
Re: STTNG Gun Assembly Plastic Arm
« Reply #5 on: August 20, 2011, 12:15:05 AM »
Pretty much.