« previous next »
Pages: [1]   Go Down

Author Topic: help  (Read 227 times)

0 Members and 3 Guests are viewing this topic.

Offline jason76

  • Trade Count: (0)
  • **
  • Forum Posts:
help
« on: November 04, 2009, 08:45:42 PM »
i guys just bought a full flipper kit. having trouble gettn d soft solder to stick to, using 60/40 . do i need to use flux or do i need to use different solder. i think it needs to be cleaned with acid so it sticks . any help would br great

cheers

jason
Logged

Offline Retropin

  • Trade Count: (+4)
  • ******
  • Forum Posts:
Re: help
« Reply #1 on: November 04, 2009, 09:03:05 PM »
Yes - there will be grease on the wires. Use some Bakers solder flux - just dip a cheap paint brush in and apply to the bare wire, then with a loaded and HOT soledring iron you should be able to tin the wire... sometimes you might need to let soak for 30 secs or so.

Good luck mate ^^^
Logged

Offline ktm450

  • Trade Count: (+1)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Geelong, Victoria
Re: help
« Reply #2 on: November 05, 2009, 10:43:50 AM »
If you don't have flux, try some steel wool or sand paper to rub down to clean metal, then try again
Logged

Offline Dirty daz

  • Trade Count: (-1)
  • *****
  • Forum Posts:
Re: help
« Reply #3 on: November 05, 2009, 03:05:40 PM »
strip back the wire thn use a small file to clean up the wire ..DAZ..
Logged
Pages: [1]   Go Up
« previous next »