systen 80 help needed

[studley67]

can anybody help me out with the pin connections from A3j1 to A1J4.looks to me like both sides of the boards are used.much appreciated.damien

[ddstoys]

Ill just go have a look for you what info were you after?

[studley67]

i need the connector wiring pinout for the little loom that is missing in my project machine.driver board a3j1 to mpu board a1j4

[studley67]

picture

[ddstoys]

Well looking at my loom its to hard to explain ill try make up a diagram for you

[Strangeways]

What game, Damien ?

[studley67]

nino its a HAUNTED HOUSE....just kidding. genesis sys80b

[ddstoys]

Mine is a Sytem 80b aswell ill get onto that diagram right away sorry for the delay i just finished work

[ddstoys]

Dont laugh to hard at my attemp this diagram is with both plugs sitting on the table looking at where the wires go into the plug the black is  slot with no wires the purple is the key and the rest just have wires running from each hole to the same hole on the other plug hope this makes sense

[studley67]

thanks for your help.but can you please double check.i have zoomed in on the photo and the wires at each end of the connectors(where both pins either side of the connectors are used)seem to be swapped front to back.could you confirm this please?

[ddstoys]

When the plugs are layed flat as they would be in the machine every plug goes from front to back ill take some pics of mine for you once my camera charges

[studley67]

you have drawn it correctly.my mis-understanding.your drawing was upside down to me.took me a while to decipher.lol.thankyou,regards damien

[ddstoys]

Here are some pics of the actual plug might help?

[studley67]

thanks very much for your time cheers damien