Aussie Pinball Forums > Pinball Training 101
Bally World Cup Soccer Goalie Ball Popper issues.
copaww:
Hi all, looking for a solutions my 94 WCS goalie ball popper unit. The ball popper rarely has the strength to shoot a solutions9goal and usually will not come out of its hole. Had the coil replaced with a heavier duty one which worked really well for a few games but it has gone back to doing the something.
Any suggestions for a learner to the pinball scene.
Regards
Allan
ktm450:
%)% check everything is free, the arm is not rubbing on the plastic cup and the coil sleeve is clean so that the plunger can slide easily when the coil is activated
casperthefriendly:
Sounds like a mechanical issue. Check the coil sleeve, spring and linkage that actually kicks the ball out - sometimes these need a little "adjusting" (bending) to give good results.
Strangeways:
Very common problem. Most of the time it will be a physical issue. With the game off and the playfield raised, you need to check a few things ;
Move the kicker by hand. Feel for resistance.
Remove the coil bracket. Feel for resistance. If any part of the assembly was previously lubricated, you need to remove the assy, disassemble, degrease, clean and then re assemble.
Check the alignment of the bracket in relation to the coil bracket. The plunger must move freely, and you can pivot either the coil bracket OR the assembly itself.
The assembly should move easily by now.
If not, try another spring - one that has a higher tension. I've found this to work when all else fails..
studley67:
great advice ^^^had one of these.
Navigation
[0] Message Index
[#] Next page
Go to full version