Author Topic: Sttng cannon wire harness  (Read 327 times)

0 Members and 3 Guests are viewing this topic.

Offline BioBa

  • Trade Count: (0)
  • ***
  • Forum Posts:
Sttng cannon wire harness
« on: November 09, 2014, 12:58:40 AM »
Does anybody know if I can get the STTNG the cannon harness in Australia?
Thanks.

Offline ddstoys

  • Trade Count: (+23)
  • ******
  • High Score Initials:
  • Forum Posts:
  • Geelong
Re: Sttng cannon wire harness
« Reply #1 on: November 09, 2014, 01:46:39 AM »
I know I have new cannon covers tucked away I'm pretty sure there were new harnesses Aswell ill have a look tomorrow

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
  • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: Sttng cannon wire harness
« Reply #2 on: November 09, 2014, 11:05:28 AM »
I've not seen them sold in Australia. The only place I've seen them are on eBay from the UK.
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia

Offline shaneo

  • Trade Count: (0)
  • ***
  • Forum Posts:
  • Canbraahh
Re: Sttng cannon wire harness
« Reply #3 on: November 09, 2014, 01:14:20 PM »
They are not difficult to put together yourself and make the far better than the originals. There are 8 wires  - 2 for the coil, 2 for each opto tx/rx and 2 for the  lamp. A bit of heatshrink or cable mesh covers for the wires, some connectors and you are done. You can re-use the old connectors if you don;t have any on hand and I've even seen 4 pair Telecom cable used in a pinch.

Offline BioBa

  • Trade Count: (0)
  • ***
  • Forum Posts:
Re: Sttng cannon wire harness
« Reply #4 on: November 21, 2014, 12:46:02 AM »
That's what I did at the end. Reused the connectors and soldered the new wires on. gave up trying to find the three different connectors and had no idea what size pins need to be crimped on.