shooter rod old ss

[pinball god]

Looking for new or used shooter rod similar to the one pictured. Can have point or not. This one off my embryon is too short and miss plunges a lot. I am guessing this could be the pspa ones as I think this is where the game originally came from.

Thanks guys

[swinks]

whats the length of your shooter rod from back of the knob to the tip of the rod?

that just sounds wrong 

[pinball god]

Incorrect rod shaft length is 187mm approx, modern dmd shaft length 197mm

[swinks]

here is a good supplier that is hard to find

http://thepinwitch.com/gx2/index.php?cat=c12_Shooter-Rods-and-Parts-Shooter-Rods-and-Parts.html&cPath=12&page=2

[pinball god]

Thanks mate. I have temporarily put a dmd shooter on the game to make it playable. I changed the sleeve, spring, bent the shooter cover prongs until I realized the rod is the prob. Talk about looking in the wrong places 

[pinball god]

Sorry guys, just found a shooter that will do the job. You just don't know what you have for spares until you decide to clean up the garage 

[MrMaloo]

If the one you pictured is just too short you can fix it by putting a spacer / small rubber ring at the end of the rod before you put the rubber shooter tip on . It will space the shooter tip off a bit more and make better contact with the ball .

[pinball god]

Not sure what you mean

[swinks]

pretty sure he mean you can drop a small dia washer or equivalent dia piece of steel / rubber inside the plunger rod tip rubber and then install the tip rubber onto the rod which effectively makes the rod reach longer.

[pinball god]

Oh I needed about 10mm