« previous next »
Pages: [1]   Go Down

Author Topic: Firepower problem  (Read 175 times)

0 Members and 1 Guest are viewing this topic.

Offline lenoz

  • Trade Count: (0)
  • **
  • Forum Posts:
Firepower problem
« on: April 14, 2011, 07:12:31 PM »
Hi all, when i turn on my Firepower the ball loads into chute by itself then blows fuse, the coil does not lock on but just activates as soon as you power on machine and loads ball, any suggestions, thankyou.
Logged

Offline ddstoys

  • Trade Count: (+23)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Geelong
Re: Firepower problem
« Reply #1 on: April 14, 2011, 07:44:28 PM »
Sound like a locked on transistor for the ball release coil I'll try find the transistor number for you
Logged

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: Firepower problem
« Reply #2 on: April 15, 2011, 04:21:36 PM »
Quote from: ddstoys on April 14, 2011, 07:44:28 PM
Sound like a locked on transistor for the ball release coil I'll try find the transistor number for you
+1 on the transistor. + the coil is probably also cooked if its blowing the fuse.
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)

Offline MartyJ

  • Trade Count: (+4)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Melbourne
Re: Firepower problem
« Reply #3 on: April 15, 2011, 05:18:30 PM »
Q29 & Q28..

http://www.firepowerpinball.com

Are you handy with a multimeter to check these Lenoz?
Logged
Pages: [1]   Go Up
« previous next »