My solenoid driver board is an new Alltek solid state so I hope something hasn't fried there. When I installed the new connector, I cut, replaced the ends, and put them into the new connector housing one at a time to make sure I didn't swap any, but of course that doesn't mean they were right to begin with. They identically match where they were in the old connector. I've attached a before picture as well as the schematic that makes no sense to me if you could please take a look at it. There was a solid orange wire soldered directly to my recitifier board right above where the burnt out spot on that old connector was, so my assumption was that it went there so that's where I installed it into the new connector.
Thanks for the part number on the shooter, but I can't seem to find it with a Google search. Any idea where I might be able to find it?
Thank you again for your help. I appreciate it very much.
EDIT: The relay on the driver board does click on boot. Just double checked it to be safe.
