« previous next »
Pages: [1]   Go Down

Author Topic: System 11 MPU 5 Volt help  (Read 460 times)

0 Members and 2 Guests are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: System 11 MPU 5 Volt help
« on: May 27, 2012, 01:57:11 AM »
there is not much between the +5V input and the test point.
If your power supply is strong enough to run the board (I only use a regulated power supply) then some has gone short circuit on the board.
what ever has failed in this situation will get hot.
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)
Pages: [1]   Go Up
« previous next »