« previous next »
Pages: [1]   Go Down

Author Topic: Fitting 2 wires to a Molex crimp pin / contact  (Read 2350 times)

0 Members and 2 Guests are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: Fitting 2 wires to a Molex crimp pin / contact
« on: July 07, 2012, 01:14:45 PM »
Twist the 2 wires tightly together and tin them with solder, make sure you remove any excess solder, you want them to be as narrow as possible.
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)
Pages: [1]   Go Up
« previous next »