thanks for the support guys, just keeping this post close to the front.
Updated 25-7-12
Had a few material stock issues with the supplier I wanted to go with so officially doing 1 run as per below and depending on sales and feedback and any new interest, I will look at more of silver, black, gold and even look at a blue and red mirror - sorry guys - just got to watch the wallet but also looking after the initial guys standing behind me on this one.
1st Run as follows:
1 x silver mirror - 0,8mm
1 x black mirror - 0.8mm
1 x gold mirror - 0.8mm
A few guys pulled out - totally understand so had to reduce the amount made so I am not at a financial loss but others are still looked after.
In the colours no one here in Aus does thinner so 0.8mm is the best I can do. So when you are considering, you the customer needs to determine the space - e.g. reading on Pinside machines like The Shadow are so very tight though a few guys persisted but very tight. So you the owner has to make the decision if the blades will fit because as you know machines vary and some may have slight warps etc so I can not accept responsibility for variations of fit. As for fitting to the same profile there are variances in every machine / model so again I can not design a product for every machine rather go for something to fits a large percentage. Almost every Bally / WMS will be the same except near the back board (back of the blade) e.g. a Getaway is slightly different as some guys have had to do some slight modifications to either the timber in the back of the cabinet and others using tin snipes to the blade. I would rather you be well informed rather than upset.
