Quote from: beaky on July 26, 2012, 05:20:07 PM

you may have a crook pre driver transistor Q6
as far as the replacement transistor goes you should use a IRL540 for the P20N10

Quote from: pokermachine on July 26, 2012, 06:49:52 PM

Quote from: beaky on July 26, 2012, 05:20:07 PM

you may have a crook pre driver transistor Q6
as far as the replacement transistor goes you should use a IRL540 for the P20N10

Hmm... if the q6 transistor is on the I/O power driver board then Q6 does not have a transistor... just 3 empty holes.... moon used to work fine tho.

Would using a p19nb20 insted of a IRL540 or P20N10 make the magnet not work now?

According to the manual Q6 is NOT installed.

I'm guessing that beaky was referring to the magnet driver board under the playfield.

The transistor you replaced - this was on the magnet board yeah?

yep Q6 on the playfield magnet interface board.
An IRL540 has a higher current rating and only needs 5 volts on the gate to be turned on properly and is recommended in the Clay repair guides as a replacement and i have used them myself on magnet driver boards