Author Topic: elektra issues  (Read 3395 times)

0 Members and 6 Guests are viewing this topic.

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
  • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: elektra issues
« on: October 28, 2012, 12:06:47 AM »

1. Bottom play field does not work ,lights,flippers but ball kicks out.

Check the 555 globe is working on the "Soldenoid Expander" board located under the playfield. If the 555 is not working, then the solenoids tend to play up.

2. right slingshot wont work with the 2 switches but works in its test mode.

Does the slingshot switches register in the "switch test" ?

3. 8 globes are out l checked the a few found one is 12v arn't they  all 6.3v 555.

Should be 555 6.3V

4. found 2 targets don't work. haven't really looked yet.

Switch test will confirm this.

5. left bottom flipper isn't as tight as others but still works.

Probably needs a flipper rebuild. Sounds like the spring is too loose.

6. back of the lower cabinet is stuffffeeeeedddd. needs to be fully replaced.

Ireplaced the panel on the Eight Ball I'm currently restoring. Can be done with a small sheel of 20mm ply from Bunnings and the right tools !


Thats a start !
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia