« previous next »
Pages: [1]   Go Down

Author Topic: TOM Eddy Sensor Calibration  (Read 222 times)

0 Members and 2 Guests are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: TOM Eddy Sensor Calibration
« on: December 24, 2012, 01:45:44 PM »
you are on the right track
yep, easy job if you can solder.
you will get a pot that does the job from jaycar
value of pot is 10k
« Last Edit: December 24, 2012, 01:57:15 PM by beaky »
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)
Pages: [1]   Go Up
« previous next »