Will be the corresponding scrs on the aux lamp driver, or the sockets. I'll check the schematics over the weekend.

Nino I think I may have found the problem so I don't want you to go to any trouble finding maybe what I already know. I think you are correct in that it is a pin/connector issue. I looked at the schematics and found that 3 sets of 2 globes were out on my machine pins 52,21,13. I lost 13 after reseating j2 & j3. I jiggled j3-8 and looked at theses globs and they were on again.

So unless you think otherwise, I will try reflowing solder on the pins and if this doesn't work redo the connectors.

Hope I haven't put you to too much trouble