OK all you future MET owners - not sure if you saw the post on Pinside but there has been a SIMPLE fix for the 'non dropping dead on hit' drop target issue.

The full story is here - http://pinside.com/pinball/forum/top...one-have-a-fix
But essentially you just pull the target springs off at the lowest point and replace them back on the bracket with around 5 mm of spring 'hanging over' - yes you ARE stretching your spring but not by much and it works pretty much 100%

if you bugger your spring it might end up costing you 0.25c

Anyway - keep it in mond when you get your games