« previous next »
Pages: 1 2 [3] 4 5   Go Down

Author Topic: Baywatch  (Read 4363 times)

0 Members and 3 Guests are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: Baywatch
« Reply #30 on: July 25, 2013, 09:06:24 PM »
needed to edit the first line but ran out of time again  ^&^
10.2 is a little low. is that at the 12V test point on the power supply?
this is not the same 12V that the dmd uses, it uses the 12v from BR3
check what voltage you have at the capacitor marked "for BR3 display" and at BR3 you should have around 12V
« Last Edit: July 25, 2013, 09:09:03 PM by beaky »
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)
Pages: 1 2 [3] 4 5   Go Up
« previous next »