Got the NBA FB donor machine. I always thought i would play it a bit to see how it was, anyway, after 5 minutes of playing i was too keen to get into starting the conversion..
The NBA is largely in good condition, trough opto boards and 7 opto board was missing, but playfield, ramps and most plastics are in very good condition - if anyone needs any parts, let me know!
The cabinet is pretty solid, will need a few dings and scratches repaired before putting MM decals on, but that is a long way off
Started off by removing the playfield from the machine to start stripping
I started on the underside, and removed each of the wiring harnesses
Started with the coil and flasher harness, and i labelled each plug (or cut wire pair) with a number, this number was then recorded against the NBAFB coil table, so that when i put the harness in MM, i know where that set of wires should go.
Same then with switch and light looms - switches were labelled where they attach to the playfield
The GI and controlled harnesses were all twisted together, so will be a bit of fun getting them apart.
Once all the components off the bottom were removed, all the top side was pulled off. Its amazing how much quicker it is stripping a playfield when you dont take any pictures of where things go!
Parts were then organised into stuff that i would reuse or not. Things like pop bumpers, flipper mechanisms, playfield brackets etc will be totally stripped and cleaned before being reused
Playfield all stripped now
