Update.
Decals arrived from the States.....finally. UV cured so no need for a clear coat. Have only done the decals that needed replacement. They are slightly larger than the rebate from the insert. Really not sure if I should trim? They do sit and stick very well despite my alignment on some
Mode start hole repaired. Selleys Knead it. Fantastic stuff, moulded it to the hole, and then using the Cliffy protector I pushed it hard into place. This imprinted into the Knead it, making a perfect fit. I'm really confident that the ball when ejected will not lift the cliffy.
Just about finished cleaning, polishing and buffing. Post and screw heads that looked really quite crappy, 30 seconds on the buffing wheel look like brand new.
New ramp and plastics from RTBB going in, and correct red bumper caps thanks to pinsanity.
The put back is a bit of a jigsaw, but along with Garrett Lees guide, it's all looking good.
