« previous next »
Pages: [1]   Go Down

Author Topic: Bally SS GI Issue - Triac  (Read 833 times)

0 Members and 2 Guests are viewing this topic.

Offline pinballnz

  • Trade Count: (0)
  • ***
  • Forum Posts:
    • New Zealand
    • Pinball NZ
Re: Bally SS GI Issue - Triac
« on: August 14, 2014, 10:00:34 AM »
Hmm I have an issue.

I followed the pin outs M1 to M1 and gate to gate.  soldered them on and tested and same issue with the GI.  I left the old "earth " wires on a ring connector bolted to the old triac. Should these be soldered to leg 2? Should I run a new wire and ring connector to the old triac and then solder the wire to pin 2?

Thanks
Clive
Logged
Pages: [1]   Go Up
« previous next »