a little more info to help those interested understand the mod a little more.
- basically the old snack bar plastic has to be removed before any reassembly can occur.
- then the new SS base plate (with a decal fitted) with the blue pillars will be fastened to the location that the old plastic came from. (the blue pillars will already be fitted by myself before shipping to customers). Also these blue pillars are the only 3D printed part by myself with everything else professionally made.
- then the snack bar top (with a decal fitted, as well as a dome and el wire routed) will be located onto the pillars and then 3 screws fitted to lock the mod down into place via the top side of the pillars.
I will have instructions with photos ready to send out with the mods but this gives you a general idea of assembly all with the ramps still in place with only the glass off.
You will notice the snack bar top over hanging the plate in one section, the plate steps back around behind the targets like the original plastic. I have left the snack bar top maintain a curve over the targets to keep the building curve look without obstructing the view of the targets. I made the mod solid plastic in this area, therefore it is not hollowed out and not a weak point.
I hope this helps and I will release a lot more info when the samples start rolling in with photos and video along with some transparency views showing some of the hidden detail of the top piece.
