Author Topic: Fathom Connector  (Read 185 times)

0 Members and 1 Guest are viewing this topic.

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
  • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: Fathom Connector
« on: September 03, 2014, 08:18:15 PM »
The Grey / Orange wire is simply "piggy backed" to the next coil. You can use a 2 pin connector with the three wires at one end and two at the other (going to the coil).

Due to the issues with having 2 wires on one crimp pin, I'd recommend a three pin connector.

You could also look at one "X coils + 2 " pin connector ;

One pin for the left hand lug of each of the coils and one pin for the Grey / Red. The piggy backing will be on one side of the connector. You can use 2 pins for the Grey / Red. One going in, and one going out.

So for a three coil arrangement - ONE pin for each of the coils (3) and one pin for the Grey / Orange going IN to the connector and one Grey / Orange going OUT of the connector = 5 pin connector
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia