« previous next »
Pages: [1]   Go Down

Author Topic: Basics of using a multimeter  (Read 1040 times)

0 Members and 1 Guest are viewing this topic.

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
    • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: Basics of using a multimeter
« on: April 13, 2009, 11:52:19 AM »

Good One, Andrew..

Where was this site when we were fixing your Fishtales, Wotto - or was it the Genie ?  %.%


My  :2cents: on MMs - If you have the $$ - Buy a Fluke - Mine lasted nearly 16 years. Cost around $70 back then, the equivalent is around $250 now. Some of the Jaycar / Dick smith ones are a bit dodgy - so keep the receipts if you are not happy you can return it
Logged
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia
Pages: [1]   Go Up
« previous next »