« previous next »
Pages: [1] 2   Go Down

Author Topic: embryon meltdown  (Read 1715 times)

0 Members and 3 Guests are viewing this topic.

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
    • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: embryon meltdown
« on: December 28, 2015, 04:30:06 PM »
Take a step back and ensure the CPU board is ok.

Remove the connector (J1 from memory) from the rectifier board. Check the fuses on the power supply and then you should have a booting game without J1 connected. No solenoid power or GI lighting to the playfield.

you need to check the wiring to each lamp. Sounds like a a lamp matrix wire has shorted to a coil somewhere.
Logged
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia
Pages: [1] 2   Go Up
« previous next »