« previous next »
Pages: [1] 2 3   Go Down

Author Topic: Modifying a flat bed scanner for playfield and cabinet scanning  (Read 6624 times)

0 Members and 2 Guests are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: Modifying a flat bed scanner for playfield and cabinet scanning
« on: May 04, 2009, 12:01:00 AM »
install front pcb.
Remove tape and paper.
Install large pcb, scanning bar, guide string & ribbon cables.
Clean glass and scanning assembly.
Install Glass and hold glass inplace with duct tape.
Make sure the tape doesn't sit in scanning area.

Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)
Pages: [1] 2 3   Go Up
« previous next »