« previous next »
Pages: [1]   Go Down

Author Topic: DIY hole protectors  (Read 612 times)

0 Members and 1 Guest are viewing this topic.

Offline ktm450

  • Trade Count: (+1)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Geelong, Victoria
Re: DIY hole protectors
« on: September 27, 2009, 01:19:48 PM »
Good job, just make sure the shim steel you select is stainless steel shim or eventually your hole protector will get some surface rust on it.  ^^^
Logged
Pages: [1]   Go Up
« previous next »