« previous next »
Pages: [1]   Go Down

Author Topic: Gorgar 404 problem?  (Read 232 times)

0 Members and 1 Guest are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: Gorgar 404 problem?
« on: October 19, 2009, 07:09:20 PM »
no probs
when you replace the coil just make sure its is not staying energised when you turn the pin on.
if it is staying on all the time it will burn out your new coil.
and if that is the case you may have a blown transistor or 2.
« Last Edit: October 19, 2009, 07:12:59 PM by Beaky »
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)
Pages: [1]   Go Up
« previous next »