« previous next »
Pages: [1]   Go Down

Author Topic: DIY hole protectors  (Read 617 times)

0 Members and 4 Guests are viewing this topic.

Offline shansta

  • Trade Count: (0)
  • ******
  • Forum Posts:
    • Vic...
  • I want to migrate... To Qld...
Re: DIY hole protectors
« on: December 13, 2009, 08:12:27 AM »
Quote from: ktm450 on September 27, 2009, 01:19:48 PM
Good job, just make sure the shim steel you select is stainless steel shim or eventually your hole protector will get some surface rust on it.  ^^^

+1 : The stainless should be a wee bit harder - should be a bit harder to ping? (Than mild steel)
Logged
Why is it called PMS?
Because "Mad Cow Disease" was already taken...
Pages: [1]   Go Up
« previous next »