Time for another update;
I've been busy with polishing and assembilng cabinet hardware. 1st pic shows a couple of the coin door bolts, before and after polishing. These i simply spun them in my electric drill while holding 120 grit sandpaper on a rubbing block against the bolt heads while spinning to remove the crappy looking surface, then 400 grit and then finally Auto sol polish and rag to get the shine you see here. The ball shooter rod copped the same treatment (2nd pic)
The coin door i regrained with 400 grit wet/dry paper and windex, then 800 grit and then finally Autosol polish.
The lockdown bar clamp was disassembled and cleaned up with a clean n strip disc in an electric drill, then sprayed with hammertone paint, same as i did with the Dracula lockdown bar assembly.
