« previous next »
Pages: 1 [2] 3 4 5   Go Down

Author Topic: LAH Shop Job  (Read 6302 times)

0 Members and 2 Guests are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: LAH Shop Job
« Reply #15 on: April 18, 2010, 11:30:17 PM »
this is the abrasive flap wheel that i used to regrain the guides.
i did it with a low speed battery drill.
you can buy these at  bunnings pretty cheap
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)
Pages: 1 [2] 3 4 5   Go Up
« previous next »