Strip, clean, rebuild!
Strip, clean, rebuild!
Strip, clean, rebuild!
That's what i have been doing the last couple of days...
Catapult, ball trough, slings, poppers, upper divertor, kicker, up kicker, pop bumpers and ball shooter assemblies were all stripped, cleaned and rebuilt.
I have also installed the flipper mechs onto the playfield and installed and fixed the new bats...
I had a problem where 2 out of the 3 poppers had their connectors chopped off and the wires soldered and joined together, and then covered with heat shrink. My subway ramp was also like this.
Before cutting them away from the PF i numbered both sides of the wires as in some cases coloured wires did not match on the opposite end. This was done as a precautionary measure.
I asked around for some help and thanks to Beaky for supplying me with the pin out diagram which helped me out a great deal.
You can see in the pic white tape on each individual wire on 2 of the poppers, ( explained above) i left them on for when the time comes to re assemble the poppers, as an insurance just in case i muffed up the wiring order that Beaky sent me.
Take note of the new connectors.
Not much to see but a couple of pics wouldn't hurt...
