« previous next »
Pages: 1 [2]   Go Down

Author Topic: Anyone here done the CFTBL DMD panel tail-light mod?  (Read 1452 times)

0 Members and 2 Guests are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
    • Melbourne, Vic
Re: Anyone here done the CFTBL DMD panel tail-light mod?
« Reply #15 on: May 23, 2010, 03:52:29 PM »
To get your 12volts dc you need to connect the GND (-) to pin 4 or 5 and the 12v (+) to pin 7 on the connector marked P1 on the dot matrix display.

the GND is black and the 12V + is grey with yellow dots (as per diagram)

hope this all helps.
Logged
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)
Pages: 1 [2]   Go Up
« previous next »