Author Topic: Fitting a Metal Lift Trim  (Read 289 times)

0 Members and 4 Guests are viewing this topic.

Offline TSPP

  • Trade Count: (0)
  • *****
  • Forum Posts:
  • Melbourne
Re: Fitting a Metal Lift Trim
« on: June 25, 2010, 07:53:01 PM »

Have a look and see if there is any tape in the channel. There "should be". Heat up the outside with a hair dryer and slowly pull the channel away from the glass. You might find three pieces of self adhesive felt. It is really easy to heat up the adhesive.


 !@# no tape to be seen and no adhesive at all  !@#

I dont have a mallet, should i tempt fate and use a normal hammer with padding between hammer and trim?? Lots of rags for example?
.....something witty here