Author Topic: Bally SS Voltage Problems  (Read 271 times)

0 Members and 2 Guests are viewing this topic.

Offline Boots

  • Trade Count: (+8)
  • ******
  • Forum Posts:
  • Adelaide
Re: Bally SS Voltage Problems
« on: February 13, 2011, 12:40:06 AM »
$#$

Found problem- dirty connector at driver board j3 pin 12-the lesson continues,thanks for your assistance
This is one of the ones that always go bad with over heating.
Change the connector terminals on J3 and if they are bad the header pins on the SDB, this will solve a lot of these problems re-occuring.