Cabinet cabling and tilt mechanism is back in the cabinet.  I cleaned the cabinet cabling with some Nifty, some baby wipes and an old towel and replaced all of the cable ties and cable holders.  They were quite dirty from years of grime but came up like new again.  As per the advice of others on the forum (I think it was Nino), I replaced the old power cable with a new one from Bunnings.  I just purchased a 5m extension cord, cut one end off and soldered into place.  I cleaned up the tilt mechanism board with some Nifty, Autosol and installed a new tilt ball also that was missing from the machine when I received it

Here are the pics as installed