« previous next »
Pages: [1] 2   Go Down

Author Topic: Moving on to Solonoid Driver Board  (Read 7609 times)

0 Members and 2 Guests are viewing this topic.

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
    • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: Moving on to Solonoid Driver Board
« on: August 22, 2011, 10:54:33 AM »

I would ensure the fuse under the playfield is replaced with the correct value (a SLO BLO Fuse - 1.0 or 1.5 Amp) before doing any further testing. If the coils are all good, you can put the game into test mode and run the solenoid test.
Logged
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia
Pages: [1] 2   Go Up
« previous next »