Gottlieb Parts needed

[pinballowner]

I have some pics and measurements for some parts I need for my Soccer.
In the first pic the plastic is 53mm long, 22mm wide & the holes are 37.5mm apart. It can be single or double sided. 1 of these needed.
Second pic the plastic is 68.7mm long, 19.2mm wide & the holes are 52mm apart. They don't have sides on them. 2 of these needed.
2 ball kicker plastics needed 1 red and the other orange.
If anybody has a copy of a schematic for it that they could email I would like one of those.

The Hotshot I would like plastic A-14604-L, C-14606 & the one in the middle of the field in front of the pop bumper, don't know the part number for this one. I don't need them but I would like some better ones one day.

Thanks

[Geoffh]

Try this place they may have what you need

http://www.pbresource.com/index.html

[millsy]

The lane plastics are usually listed in inches - I have 5 x 2-1/4 inch and 2 x 1-1/2 inch if you want them. One tip -they are a lot whiter than the original so it may be an idea to replace the lot - I replaced all of them on my Jumping Jack -you can have the old ones if you want.I have 6 spare post screws as well if you want them. I cut the sides off the double plastics if needed. Also have 28 spare Accorn Nuts.
Check http://www.rtbb.com.au/catalog/index.php?cPath=40_111_136&osCsid=dafa48eabbe872aa8e10b5bf7b56f065 - I think Greg has them.What State are you in.
Millsy

[pinballowner]

Thanks for the info guys. I sent you a pm Millsy. I don't know if it worked?

[illawarra_steelers]

The playfield plastics are 'in the queue' to be made as reproductions by PBR.

As the other guys have said - they are also the place to buy your lain guides. This should also give you a guide on what else you can buy from PBR for your 2 x 1970s Gottlieb pins: http://www.pbresource.com/bigindian.html

By spending around AUS$150 you could have your games looking awesome

[pinballowner]

Does anybody have a pic of the spinning chequered flag bits on their own game that they could post for me to have a look at? I found this pic
 http://www.pinball-gallery.com/images/grandes/871-3.jpg
and it is different to mine. The brackets are different. Another thing I have found is that a couple of sites say it was built in 1975 but mine has 1974 on the backglass and playfield.

A pic of mine is below

[illawarra_steelers]

The spinners on that photo are correct but as you mention the brackets are wrong (big time)

[pinballowner]

I found these pics on another site and one has the same type of brackets. Maybe a mod for Australia I think I might need to get the hacksaw out

[illawarra_steelers]

Should be like this:

[pinnies4me]

Let me know if your need any more lane guides etc - I have a lot of spares for Gottliebs.