Xenon connector help

[Crashramp]

Before i start i have to say, yes I'm an idiot. I've been replacing old connectors on my Xenon tonight and neglected to mark where I was up to on the last one ( J3 on the AUX lamp driver board in the back box) anyway I started at the bottom and worked my way up, but when I got to the last one (orange/green) it needed to go into the third point down but I didn't think there should have been a gap between this wire and the next.
The question for anyone else with a Xenon is, given that I know that starting from the bottom the first 2 wires are in the third and fourth slots up followed by two empty spots in slots 5 and 6. Where is the next empty slot? I'm confidant that the wires are in the right order but not so confidant that I have them in the right location. Help please.

[wiredoug]

its ok i understand cos im an idiot too :-)   do dumb stuff like this all the time
i have one in the shed .. i even went and had a look - and it is BLOODY FREEZING out there.

here you go sir.. see attached

[Crashramp]

That's fantastic, thank you very much 

[wiredoug]

no charge ;-) 

[Crashramp]

no charge ;-) 

Ha ha, thanks mate, if you're ever passing through Albury your welcome to drop in for a beer and a game or two.

[wiredoug]

might take you up on that one day ... got close last time.. Bought a vending machine not long back from a top bloke who runs a video shop and few machines in wodonga.

[pinoffski]

Would like to see some pic's of XeXon

[Crashramp]

Here's a few pics of the machine at the moment. Once I finish off the resto on Flash Gordon this one will be next.



The playfield has mylar and is still in pretty good nick.



But it will be a lot better once I drop the new CPR playfield into it.



Awesome detail in the artwork on this game.

[wiredoug]

Hah! ..swap "flash gordan" for "centaur" and thats my story too ..   i'll post her tonight

[Crashramp]

Hah! ..swap "flash gordan" for "centaur" and thats my story too ..   i'll post her tonight

Great stuff.    Looking forward to seeing your post.

[wiredoug]

Here she is.
As you can see she has a pretty sad playfield and needs MPU repairs too.  The new cpr gold playfield i got for it turned out to have a nasty hole in it so its away getting repaired and clearcoat redone now. 

[wiredoug]

more.  someone didnt have a rubber on their rod when they played her it seems..

[Crashramp]

Jez, someone really didn't care to spend that 25c on a new rubber tip for the shooter rod did they!
You can get new ones here. http://www.bestofpinball.de/catalog/product_info.php/cPath/41/products_id/8945
Though I haven't fully started on the resto of this machine, I've done a couple of things just to make it a better player before I get going. Here's a pic of the new shooter rod on my machine



If you see them on eBay don't buy them. I did and there to short. The best of pinball ones are the right length though.

[pinoffski]

Here's a few pics of the machine at the moment. Once I finish off the resto on Flash Gordon this one will be next.



The playfield has mylar and is still in pretty good nick.



But it will be a lot better once I drop the new CPR playfield into it.


Thanks for the pics
crashramp

Will be looking forward to seeing resto on xexon