Author Topic: Stargate Not Booting  (Read 5960 times)

0 Members and 1 Guest are viewing this topic.

Offline scottnds

  • Trade Count: (+1)
  • ***
  • Forum Posts:
Stargate Not Booting
« on: November 05, 2015, 05:16:12 PM »
Hi
I need some help with my Stargate.It has been working OK after I changed optos and have not turned it on for a week.
Now it wont boot up and I get the screen full of random numbers and symbols and some non English words and a constant beeping.
I have been searching around on the net and found that the Pot on the power supply board sometimes will play up.So I have tested and have 5.05 volts out.
Has anyone come across this before?
There was also mention of replacing resistors.
Is there anything I can do or send off board for repairs.
Thanks
Scott.

Offline Steevsee

  • Trade Count: (+1)
  • ******
  • High Score Initials:
  • Forum Posts:
  • Brisbane
Re: Stargate Not Booting
« Reply #1 on: November 05, 2015, 06:58:25 PM »
Try reseating all ribbon connectors. Do this with Power OFF!

Also check battery voltage on CPU. (Check pinwiki if unsure how.)

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
  • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: Stargate Not Booting
« Reply #2 on: November 06, 2015, 10:07:32 AM »
Top PCB LHS is the Video board. There's a socketed Chip (PAL / GAL) - gently re seat. These go bad then the game won't boot.
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia

Offline scottnds

  • Trade Count: (+1)
  • ***
  • Forum Posts:
Re: Stargate Not Booting
« Reply #3 on: November 06, 2015, 02:06:13 PM »
Thanks for the help much appreciated.
I have changed the battery and checked the chip and ribbon cables and got "control board check U3 or U6" I then turned it off and then on again and it has booted up.
I have factory defaults but I am back in bussiness.
Thanks again all.  *%*