« previous next »
Pages: [1]   Go Down

Author Topic: ball target issue  (Read 759 times)

0 Members and 2 Guests are viewing this topic.

Offline pinball god

  • Trade Count: (+1)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Melbourne
  • Metallica is here to stay
ball target issue
« on: February 13, 2016, 10:21:40 PM »
This has never happened until I have replaced the targets with new repros. What happens is the metal target guide slips out of the slot it slides up and down in. An easy temp fix but has happened twice now but unsure if its the same target on this bank or not. Definitely the same target bank though. Is there something I can adjust?
Logged
Still loving my Metallica Premium

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
    • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: ball target issue
« Reply #1 on: February 13, 2016, 10:40:54 PM »
The coil stop needs to be loosened and re-tightened after moving it slightly lower. There's too much travel for the plunger. This happens when the plunger and coil are worn.
Logged
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia

Offline pinball god

  • Trade Count: (+1)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Melbourne
  • Metallica is here to stay
Re: ball target issue
« Reply #2 on: February 13, 2016, 11:34:15 PM »
Quote from: Strangeways on February 13, 2016, 10:40:54 PM
The coil stop needs to be loosened and re-tightened after moving it slightly lower. There's too much travel for the plunger. This happens when the plunger and coil are worn.
thanks mate will get onto it either via adjustment or get ready for an rtbb order and visit from me.
Logged
Still loving my Metallica Premium
Pages: [1]   Go Up
« previous next »