IJ PoA replacement motor

[Maxprofits]

Hey All,
Not sure if this has been posted already or not.
I needed to replace the PoA motor on an IJ I'm fixing up. Clay mentions a Radio shack replacement of his site. Well I did some searching and found that DSE sells a similar motor here in Australia. Long story short, this motor works well as a replacement, the only problems are that the shaft is too long, which can easily be trimmed back (I cut mine with the side cutters) and the shaft is also a little thin (I wrapped some plumbers tape around it). For $5 plus postage I have found this to be a cheap and good replacement motor. It does move slightly faster than the original motor but I find this to be a good thing. If you wanted to slow down the motor you could always put a resistor in line to lower the voltage to the motor.
 http://www.dse.com.au/cgi-bin/dse.storefront/4c0c718802177c4c2741c0a87e010676/Product/View/P9004

Hope someone finds this helpful.
Regards,
Dan

[rads]

Thanks Dan,

I will need to do mine soon.