« previous next »
Pages: [1]   Go Down

Author Topic: Flash Gordon Lane Guide  (Read 157 times)

0 Members and 1 Guest are viewing this topic.

Offline Crashramp

  • Trade Count: (+3)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Albury
Flash Gordon Lane Guide
« on: February 08, 2013, 11:44:05 AM »
Hi,

 Can someone help me out with a correct measurement of the width (at the widest point directly behint the flipper) of the lane guides for a Bally Flash Gordon please. Mine are pretty worn and beat up so i want to make some new ones.
The main problem with them is when the ball returns down the lanes to the flippers the ball bounces up off the back of the flipper as it leaves the lane guide because the guide is so worn. See pics attached.
Logged

Offline PinPal

  • Trade Count: (0)
  • ******
  • Forum Posts:
    • Sydney, Australia
  • Pinpal Pinball
Re: Flash Gordon Lane Guide
« Reply #1 on: February 08, 2013, 02:58:58 PM »
Was going to mesasure my Flash Gordon lane guides for you, mine are worn much the same so it wont be much help.
« Last Edit: February 08, 2013, 03:04:20 PM by PinPal »
Logged

Offline Crashramp

  • Trade Count: (+3)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Albury
Re: Flash Gordon Lane Guide
« Reply #2 on: February 08, 2013, 03:59:29 PM »
Quote from: PinPal on February 08, 2013, 02:58:58 PM
Was going to mesasure my Flash Gordon lane guides for you, mine are worn much the same so it wont be much help.

No Worries, thanks anyway. With that in mind I think I'll go a heavier gauge stainless steel than the original when I make them.
Logged
Pages: [1]   Go Up
« previous next »