Author Topic: Mousin Around.  (Read 194 times)

0 Members and 1 Guest are viewing this topic.

Offline pinwins

  • Trade Count: (0)
  • *
  • Forum Posts:
Mousin Around.
« on: September 25, 2013, 03:04:22 PM »
Hello 1st post in here ,a selfish one at that. i have a bally Mousin Around and the 'constant' whitelights on the playfield are not coming on machine playing ok but fo rthat.i have the manual but cant read a wiring diagrame/matrix.
i have checked the strap connection from the power board to make sure it was hoding tight.but no change.... any ideas appreciated.

Offline robm

  • Trade Count: (+1)
  • ******
  • Forum Posts:
  • Townsville
Re:
« Reply #1 on: September 25, 2013, 04:16:23 PM »
Could be a simple problem like a fuse blown. Look for the general illumination or GI fuse

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
  • Melbourne, Vic
Re:
« Reply #2 on: September 25, 2013, 09:25:06 PM »
Could be a simple problem like a fuse blown. Look for the general illumination or GI fuse
+1
also check the connectors on the interconnector board to see if they are burnt out
the interconnector board is the long skinny board at the bottom center in the back box

check fuses F1 to F4
check connectors J6 and J9
if the lights behind the translight (back glass) are lit ok then bridge rectifier should be ok.

if the G.I behind the translight are also out the check the connections on the bridge rectifier and fuse in the right bottom corner of the back box next to the interconnector board (the fuse sits on the side panel of wood in the back box)
also check the fuse in the right bottom corner of the back box (only if all the G.I. are out including the ones behind the translight)
if this fuse is blow and you replace it and it blows again then it is safe to say that the bridge rectifier has failed
 
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)

Offline Boots

  • Trade Count: (+8)
  • ******
  • Forum Posts:
  • Adelaide
Re:
« Reply #3 on: September 25, 2013, 10:16:54 PM »
Could be a simple problem like a fuse blown. Look for the general illumination or GI fuse

hehe sounds like the sales pitch on an ebay listing  %.%

Offline robm

  • Trade Count: (+1)
  • ******
  • Forum Posts:
  • Townsville
Re:
« Reply #4 on: September 26, 2013, 08:38:38 AM »
Ha ha true that!