« previous next »
Pages: [1]   Go Down

Author Topic: TZ clock help.  (Read 189 times)

0 Members and 1 Guest are viewing this topic.

Offline rads

  • Trade Count: (+1)
  • *****
  • Forum Posts:
TZ clock help.
« on: January 19, 2010, 03:31:03 PM »
Hi,  just for something different, I am having issues with my clock.  The clock will only move forward at fast speed in any test mode and is otherwise not working, other than at startup where it turns at the same fast speed and stops when it feels like. Changing the speed and direction in test has no effect.  All the optos register correctly in the test and the clock was tested in another machine and worked. Any ideas would be appreciated.

Thanks
Logged

Offline rads

  • Trade Count: (+1)
  • *****
  • Forum Posts:
Re: TZ clock help.
« Reply #1 on: January 28, 2010, 07:05:07 AM »
Still struggling with this.  I have tested the motor board in another machine and it also works fine.  The clock still moves forward only in test and does so as soon as you enter test mode, even when test mode says it is stopped.  Any ideas on where i should test next?
Logged

Offline pinsanity

  • Trade Count: (+2)
  • ******
  • Forum Posts:
Re: TZ clock help.
« Reply #2 on: January 28, 2010, 08:39:58 PM »
Might pay just to recheck the two connectors on the base of the clock are plugged in correctly?

Not 1 pin off or 1 row forward/backward.

Its easy to do (from personal experience).
Logged

Offline rads

  • Trade Count: (+1)
  • *****
  • Forum Posts:
Re: TZ clock help.
« Reply #3 on: January 28, 2010, 09:27:38 PM »
Checked the plugs and they are in ok.  I am going to replace the connectors to the motor board.  Any other ideas appreciated
Logged
Pages: [1]   Go Up
« previous next »