Assuming you are talking about the little connector in the lower left hand corner of this board:



GPE has the original parts.

19-09-1026 is the male
That is the GPE and the Molex P/N, the linked datasheet at GPE is not the right picture, but I've bought these and that is the right part. It goes on the 2 yellow wires.
15-31-1026 is the female jack that mounts to the board.
Same deal, GPE P/N is the same as the molex P/N.

Looks like this, once repaired (note I had to extend the 2 yellow wires, were just too short...



Don't forget to fuse 1 of the AC leads of each bridge, while you're in there working :) I've fixed games where the bridges weren't fused per the WMS recommendations, and it's not fun, clean or easy! 2 fuses and holders are CHEAP insurance.