Author Topic: How do you do this? (Read 473 times)

bigdaddy · « **on:** July 05, 2009, 08:37:29 PM »

Need to replace the spring which is attached on end. (see picuture) there is a pin holding the spring in. Apart from trying to bash it out -the pin that is. Any tips on removing the spring?

The pinballist formally known as Dean Morgan · « **Reply #1 on:** July 05, 2009, 08:39:37 PM »

Did Mark C take that picture for you

bigdaddy · « **Reply #2 on:** July 05, 2009, 08:41:09 PM »

Quote from: The pinbalist formally known as Dean Morgan on July 05, 2009, 08:39:37 PM

Did Mark C take that picture for you

Very funny. We must meet - maybe we are brothers (Mark)

illawarra_steelers · « **Reply #3 on:** July 05, 2009, 09:05:38 PM »

Quote from: The pinbalist formally known as Dean Morgan on July 05, 2009, 08:39:37 PM

Did Mark C take that picture for you

Would love to offer some advice but can't see the problem....are you able to take a better photo?

millsy · « **Reply #4 on:** July 05, 2009, 09:07:53 PM »

Knock the cotter pin out with the correct pin punch - I think unless my over 50 eyesight deceives me

bigdaddy · « **Reply #5 on:** July 05, 2009, 11:25:04 PM »

Quote from: millsy on July 05, 2009, 09:07:53 PM

Knock the cotter pin out with the correct pin punch - I think unless my over 50 eyesight deceives me

Thanks - now where to get a in puncher..

.. I'm must looking after you with the soft focus on the picture.

millsy · « **Reply #6 on:** July 05, 2009, 11:38:53 PM »

Usually sold as a set (Punch Kit) obtained from any Automotive shop (Auto One,Repco etc),not too expensive.
Thats if that is a cotter/clevis pin

.A clearer picture would verify this.

News:

Author Topic: How do you do this? (Read 473 times)

bigdaddy

How do you do this?

The pinballist formally known as Dean Morgan

Re: How do you do this?

bigdaddy

Re: How do you do this?

illawarra_steelers

Re: How do you do this?

millsy

Re: How do you do this?

bigdaddy

Re: How do you do this?

millsy

Re: How do you do this?