Author Topic: flipper staying up after button is released?  (Read 414 times)

0 Members and 1 Guest are viewing this topic.

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
  • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: flipper staying up after button is released?
« on: May 11, 2009, 10:38:48 AM »
The EOS looks OK, the coil on the left is getting pretty warm compared to the right hand side.

The flipper shaft moves freely, no binding at all.

Any ideas?

EOS might look OK, but it may not be. Double check this. Sounds dodgy if the left coil is getting warm.


That sounds correct.

The EOS needs adjustment - dead giveaway is the the coil is warm. Could also be the diode on the coil - but the EOS sounds more likely.

Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia