« previous next »
Pages: [1]   Go Down

Author Topic: Harlem G/T problem  (Read 562 times)

0 Members and 1 Guest are viewing this topic.

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
    • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: Harlem G/T problem
« on: August 21, 2009, 05:22:46 PM »
Quote from: pinfrog on August 21, 2009, 05:06:58 PM
Thanks again ,connectors on the MPU board seemed to be the problem.

Lightly sand the pins in the connector with 360 Wet/Dry. Reinsert the connector housing and then push each wire into the connector.

In the future - you may need to replace the pin connector and pins
Logged
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia
Pages: [1]   Go Up
« previous next »