« previous next »
Pages: [1]   Go Down

Author Topic: Switch problem  (Read 186 times)

0 Members and 2 Guests are viewing this topic.

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
    • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: Switch problem
« on: January 20, 2011, 11:48:13 AM »
Quote from: rads on December 27, 2010, 07:20:27 PM
I had to replace all the switch connectors on the opto pcb and the CPU.  I was getting phantom registers and firings.  Manipulate the wires just back from the connectors and see if anything happens

+1 Sounds like a connector issue. Did you recently add LEDs ?
Logged
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia
Pages: [1]   Go Up
« previous next »